ماژول یکنواخت کننده حرکت درایور استپر موتور/ نمونه ساز

ماژول یکنواخت کننده حرکت درایور استپر موتور Stepstick Protector

کد محصول: Stepper Motor Driver Filter
موجودی: 3
بازدید: 7895

قیمت : 77,813 تومان

تعداد :

توضیحات
نظرات (0)

این ماژول برای یکنواخت کردن حرکت استپر موتور بر روی درایور استپر موتور نصب می شود و با درایو رهای TMC2100, TMC2130, TMC2208 ,A4988,DRV8825, سازگار است با استفاده از این ماژول جریان ارسالی به موتورهای شما یکنواخت خواهد شد

Stepstick protector plug is an add-on module to protect precious stepper motor drivers. It is compatible with DRV8825, TMC2100, TMC2130, TMC2208, A4988 stepper drivers. Comes in both kit and pre-assembled forms. Kit forms come with pin headers you must solder in place, pre-assembled comes with the pin headers already installed.

Description	Pin Name
Connected to 5V and GND of Controller	VIO & GND
Used to power the motor	VM & GND
Connected to the 4 motor coils of Driver	M1A, M1B, M2A, M2B
Motor Direction Control pin	DIR
Steps Control Pin	STEP
Connected to Microstep Selection Pins of Driver	CFG1, CFG2, CFG3

Features

    Smoother for stepper motor drivers such as A4988, DRV8825, TMC2100, TMC2130, TMC2208, LV8729
    Filters the current sent to your stepper motors
    Easy to install
    Plug it between your existing stepper driver and your electronic board.

Other Stepper Drivers

TMC2100, TMC2130, TMC2208

Introduction to StepStick Protector

The StepStick Protector is an add on module for stepper motor drivers. It is compatible with StepStick and Pololu A4988 stepper motor drivers. This protector board has freewheeling diodes for the motor outputs, Freewheeling/ Flyback diode is a diode that is connected between the driver’s outputs and the driver power input pins to prevent the high voltage development across the pins, so this module also protects from induction voltages in the unpowered state of the driver.

The Protector module has an additional diode between the logic supply voltage (VIO) to the motor supply voltage (VM). So whenever the motor supply voltage (VM) is not present then it will not be able to enable the motor outputs because the current will be drawn from the logic supply VIO. Pinout and internal connections of Protector Board is shown in below image. As you can see in the diagram, total 8 diodes are connected between motor outputs and one diode is connected between VM and VIO to protect the stepper motor and driver module from high voltage.

How to Use StepStick Protector

You can directly plug this protector between your existing stepper driver and your electronic board. The StepStick protector is hardware/pin-compatible with DRV8825 and Pololu A4988 drivers. However, the Trinamic TMCxxxx drivers have different and more settings, which can be set via the CFG/MS pins. The direction is inverted on TMC2xxx SilentStepSticks (DIR pin inverted) and can be either changed in the software or by rotating the motor connector 180°.

Applications

    Used to control the speed and rotation of stepper motor more efficiently.
    It is used to protect the driver modules.
    Used to eliminate the printed marks produced by 3-D printers.